Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2367
    tone66
    Spectator

    Hi,
    I install software as you recommended on your installation manuals, but after create project, I cant use Construct wall operations. It show start point and later I can’t finished wall end point. ( also no visible wall contour during drawing)
    I create new projects, make imperial units defaults, close program and start again, but there is no option to draw walls successfully.
    I try to install program on Sketchup 2015, and later on fresh install Sketchup 2017, with same results?
    I also recognize there is no Cut list Bridge on File directory.
    Should I install some other important extension with cabwriter?
    Regards Hinko

    #2370
    chiefwoodworker
    Keymaster

    Hi Hinko,
    What operating system are you on? Can you draw a cabinet or does none of the CabWriter features work? Did you do a clean install? That is, did you go to your plugins folder and delete the cabwriter and cutlist_bridge files and folders?

    I just downloaded version 0.9.3 from the website and installed it with no problem on a PC. I haven’t tried it on a Mac, but Greg has. So I would normally assume that you have an installation problem, except, you have installed it on three different machines and had the same problem. Perhaps you had a problem in download. Try downloading it again.

    By the way, what you download from the website is a .zip file. SO you first have to open that file and extract the .cabwriter_0.9.3_beta_released_1-30-17.rbz file before installing. Also, there is only one .rbz install file because I combined the two programs. So when you do the CabWriter install you should find the Extended Entity Info dialog box under the Window menu.

    If you continue to have problems let me know and we can set up a phone call for support or perhaps a network screen session.

    Joe…..

    #2372
    tone66
    Spectator

    Hi Joe
    I try several times and It works now, I persume it was some install problem, or maybe unit settings ( I use decimal units not fractional).
    Maybe it will be fine for other new users to introduce all folder places where Cabwriter must be present. ( For WIN 7,8,10 amd MaC users).
    Thanks for suggestion, Hinko

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.