February 8, 2018 at 3:50 pm
#8396
Spectator
Thanks Joe,
I do have a follow-up question, though.
For the imported cabinet drawer boxes, I redrew the sides so they were exactly 1/2″ thick, and after making them custom CabWriter parts, I assigned them the same milled part info as the 1/2″ back panels (Sheet Good, Maple ply).
However, they will not show up on the CNC DXF export. Is this because they are not a cabinet “Box” type? I know I can export the extra 1/2″ parts and then import them after I open the 1/2″ DXF file CabWriter creates. I was just wondering if there was a way to let CabWriter take care of it all and save a couple of steps.
Thanks,
Steve