#54990
HomeProjectsLLC
Spectator

Good evening, I was curious to know if the plywood thickness could be changed to be more representative of the actual thickness. Say for 3/4″ input 23/32″ and 1/2″ input 7/16″. I believe that I was able to make this type of change in an older version I had on my Mac but recently upgraded and noticed that when I try to enter 23/32″ and hit update it defaults back to 3/4″ when I change tabs or close the editor and open it back up (the 7/16″ stays so 16th may be the lowest fraction now). Not sure if this is possible or if there are other parameters that need to be changed before doing the thickness. This build will be frameless as well (if that makes a difference).

Thank you for any and all help!

RBG