#2506
chiefwoodworker
Keymaster

Hi Guys,

I am looking at implementing overlay doors and I have some comments and questions:
1. I assume that overlay doors always use face frames and that the face frame always includes a lower rail. Is this correct?
2. In cabinets with two doors I assume there is no mid stile between the end or connector stiles i.e. where the two doors meet with a gap between them. Correct? If you want a mid stile for this first implementation you will have to add it yourself; a simple matter for creating a component and using the Re-Name Component tool.
3. I assume that the hinges mount on the stile and door and not to the sheet good side. Therefore no hinge holes are drawn for overlay doors. Correct?

Are there any other thoughts before I begin implementation?

Joe….